Demo application for GRiSP boards. It includes grisp_connect to interface with grisp.io services, and grisp_updater to enable software updates.

To generate the firmware image to write on the GRiSP board EMMC, run:

rebar3 as dev grisp firmware -i

or:

rebar3 as prod grisp firmware -i

This generate the system firmware to update a single system partition, and the full EMMC image to reset the GRiSP board EMMC. See rebar3_grisp documentation for more information on how to write firmwares.

To create a software update package, run:

$ rebar3 as dev grisp pack

or:

$ rebar3 as prod grisp pack

This will generate an unsigned package, for the package to be verified you need to:

• Change the configuration key signature_check to true.

• Add the public key into priv/certificates/updates.

• Generate the package with either:

  $ rebar3 as prod grisp pack -k private_key.pem
  $ rebar3 as dev grisp pack -k private_key.pem
  

Note that updates will be verified only after this change itself is installed on the board.

See rebar3_grisp documentation for more information on how to update.

Add your development server certificate if it is self-signed, or the development CA certificate used to sign the server certificate into priv/certificates/servers.

e.g.

ln -s $MY_SERVER_REPO/priv/_dev_certs/www.seawater.local.CA.pem priv/certificates/servers/www.seawater.local.pem

The local development release runs on the host itself and connects to a local server.

Add an entry in your local hosts file so the domain www.seawater.local points to your local development server. Remember to configure the local server to check the client certificate against the grisp_connect test CA.

Start a local development shell:

rebar3 as local shell

Run tests:

rebar3 ct

The development release runs on a GRiSP board and connects to a local server.

Add an entry in the grisp hosts file so the domain www.seawater.local points to your local development server.

e.g. using ifconfig command (MacOS and older linux):

mkdir -p grisp/grisp2/common/deploy/files/etc
echo "$(ifconfig | grep 'inet ' | grep -v 127.0.0.1 | awk '{ print $2 }' | head -n 1) www.seawater.local" >> grisp/grisp2/common/deploy/files/etc/hosts

e.g. using ip command (Newer linux):

mkdir -p grisp/grisp2/common/deploy/files/etc
echo "$(ip addr show | grep 'inet ' | grep -v 127.0.0.1 | awk '{print $2}' | cut -d/ -f1 | head -n 1) www.seawater.local" >> grisp/grisp2/common/deploy/files/etc/hosts

The deploy the release, configure rebar3_grisp's deploy configuration in rebar.config and then run:

rebar3 as dev grisp deploy

To generate the firmwares:

rebar3 as dev grisp firmware -i

To create a softwre update package:

rebar3 as dev grisp pack

The production release runs on a GRiSP board and connect to a production server.

To deploy on GRiSP hardware for production, configure rebar3_grisp's deploy configuration in rebar.config and then run:

rebar3 as prod grisp deploy

To generate the firmwares:

rebar3 as prod grisp firmware -i

To create a softwre update package:

rebar3 as prod grisp pack