Description
P1IB-ext is shipped complete – ready to be plugged into your power meter.
This product is equipped with an external antenna.
Included:
- P1IB-ext.
- P1-cable (RJ12) (shipped with 0.5m length. If you want a longer, 1.5m, please write a message during checkout).
- 35cm cable with SMA connector together with a nut and two washers.
- +3dBi patch WiFi antenna with SMA connector.
Note. The antenna cable is very sensitive against force and must not be bent, twisted or misshandled. Use caution when installing the device.
Features
- Fully configurable via web UI.
- WiFi access point
- DHCP/static ip
- MQTT settings
- And lots more…
- Dashboard in web UI with realtime updated graphs for the majority of measurement points from the power meter.
- Supports both protocols that the Swedish meters use at this moment:
- DLMS/COSEM AXDR/HDLC Mode E (Aidon).
- DLMS/COSEM ASCII Mode D (the other ones).
- MQTT support.
- Automatic sensor registration for Home Assistant (MQTT Auto Discovery).
- Supports OTA firmware update via web ui (official builds fetched from p1ib github repo).
- Webservice with JSON response of meter data.
- Reduced data mode
- Logging/debug through UDP to a remote computer and/or USB serial.
- P1IB does not require any internet connection (with the exception for over-the-air firmware updates).
More information and screenshots @ https://remne.tech/p1ib/
Documentation and installation instructions @ https://github.com/remne/p1ib
Note. P1IB does not work on older Kamstrup meters, as they are not DMSR compatible. All other meters with P1-port (RJ12) deployed in Sweden are supported.
